NEMA 17 Mounting Plate Drill Guide

About NEMA 17 Mounting Plate Drill Guide

This is drill guide is for fabricating your own mounting plate for a NEMA 17 stepper motor.  The tabs on one side allow for centering on a 2 inch wide flat bar or the guide can be used on the non-tabbed side to mark drill spot on a flat bar of any width. 

At a print height of 0.4mm, it will be about 13 layers.  The height is 5.2mm.

For this to be effective for correct drill hole spacing you need to have an accurate 3D printer (but that goes without saying).

Comments (
0
)



More From Hudson 3D


Printcisely™ 3D Printing Community
Printcisely™ 3D Printing Community

Comment

You must be logged in to comment.

Click Here To Login



Close